Manual 274
Zero Positions
Pressing this soft key zeroes all axes positions.
Rip Cutting
When the Manual Mode window displays Rip Cut, the arrow keys can then be used to initiate a cut
sequence and machine motion in the direction chosen.
To initiate a Rip Cut, first ensure that the proper cut-mode (Oxy or Plasma) was previously selected.
Next, make sure that the proper cut speed is displayed in the Cut Speed window (editable in Rip Cut
mode) and then press the arrow key corresponding to the desired start direction for the cut. The
cutting sequence proceeds even after the key is released; however, machine motion is generated
only as long as an arrow key is held down, unless the latched manual key feature has been
enabled. Use the various arrow keys to change direction and the cutting device will continue to
operate until the Stop, Cancel or Manual Key is pressed.
To Next Page
Loading...
Need help?
General
