DXF Import 482
be cut. Since the Lead-in and the first cut segment have already been executed the Lead-out
segment would be the only segment left available.
Comments:
There should be nothing on the Cut Layer except Lines, Arcs, Circles and Text / Directional
commands.
Line segments must be connected to complete the cut path.
If multiple line segments or arcs need to be repeated, each line segment should be drawn rather
than copied and pasted.
Features for Marking are not available at this time.
No Traverse lines are required. All lines in the CAD drawing are assumed to be cut lines.
Left Kerf is assumed.
To Next Page
Loading...
Need help?
General
