9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-8
The EMR (Enhanced Monitor Request) communication
function can be used in only the DV mode. Using the
EMR function, no call sign setting is necessary.
All transceivers that receive an EMR signal automati-
cally open their squelch to receive the signal.
When an EMR signal is received, the audio will be heard
at the preset level, even if the volume setting level is set
to the minimum level, or the digital call sign/digital code
squelch is used. (Default: OFF)
If the volume setting level is higher than the EMR set
level, the audio will be heard at the higher volume set-
ting level.
NOTE: The EMR function is automatically turned OFF
when the transceiver is turned OFF.
q Hold down
for 1 second.
• The DR screen is displayed.
w Push D-pad() to select “FROM,” and then push D-
pad(Ent).
e Push D-pad() to select “Repeater List,” and then
push D-pad(Ent).
r Push D-pad() to select “11: Japan,” and then push
D-pad(Ent).
t Push D-pad() to select “Hamacho,” and then push
D-pad(Ent).
• “Hamacho” is displayed on “FROM”.
y Push [MENU] .
u Push D-pad() to select the root item (“DV Set”),
and then push D-pad(Ent).
i Push D-pad() to select “EMR,” and then push D-
pad(Ent).
o Push D-pad() to select “ON.”
!0 Push [MENU] to exit the MENU screen.
• “EMR” appears.
!1 Push [PTT] to transmit.
• The TX/RX indicator lights red.
• “EMR” blinks on a station that receives the EMR signal.
And the audio (voice) will be heard at the specified level,
or the [VOL] control level, whichever is higher.
!2 Release [PTT] to receive.
!3 To cancel the EMR function, select “OFF” in step o,
as described above, or turn OFF the power.
Appears
Example: To transmit from the “Hamacho” repeater us-
ing the EMR function
■ Using the EMR communication function
To Next Page
Loading...
Need help?
General
