13
SCAN OPERATION
13-9
■ Memory scan
Repeatedly scans all programmed Memory channels.
There two types of scan in the memory mode; Memory
scan and memory bank scan.
• Channels set as “PSKIP” or “SKIP” are skipped during
a scan.
• Two or more memory channels, which are not set
as skip channels, must be programmed into start a
memory scan.
D Memory (skip) scan
The memory channels set as “PSKIP” or “SKIP” skip
channels are not scanned.
q Push [M/CALL] one or more times to select the
Memory mode.
w Hold down [SCAN] for 1 second.
e Push D-pad() to select the scan type.
• ALL : Full scan
• BAND : Band memory scan
• MODE : Mode memory scan
• DUP : Duplex scan (p. 13-2)
( Appears only when duplex is set on the chan-
nel.)
• TONE : Tone scan (For tone scanning)
r Push D-pad(Ent) to start the scan.
• If desired, rotate [DIAL] to switch the scanning direction
during a scan.
• The scan resumes even while the MENU screen is dis-
played.
t To cancel the scan, hold down [SCAN] for 1 sec-
ond.
• Pushing [CLR] also cancels the scan.
TIP: Holding down [SCAN] and then rotating
[DIAL] also selects the scan type. The scan immedi-
ately starts when [SCAN] is released.
Hold down [SCAN]
for 1 second.
When a signal is received.
Memory channel
number
[DIAL]
Push [M/CALL] .
Blinks
Blinks
Blinks
Blinks
The S-meter shows the
received signal strength.
Push D-pad() to
select, then push
D-pad(Ent).
To Next Page
Loading...
