11
VOICE MEMORY FUNCTION
11-12
The transceiver can record the transmit and receive au-
dio into the same file.
q Push [MENU] to enter the Menu screen.
w Push D-pad() to select the root item (Voice Memo),
and then push D-pad(Ent) to go to the next level.
( MENU > Voice Memo > QSO Recorder > Recorder
Set > File Split)
e Refer to the menu sequence shown directly above
and push D-pad() to select, and then D-pad(Ent)
to enter, one or more times until the last screen is
displayed.
r Push D-pad() to select “OFF,” and then push D-
pad(Ent) to save.
• OFF: The transceiver records the transmit and receive
audio into the same file.
• ON: The transceiver records the transmit and receive
audio into each files.
The transceiver makes separate new files for trans-
mit and receive audio. (Default setting)
• When you set the RX REC Condition item to
“Squelch Auto,” the transceiver records audio to
the new file when the squelch is closed.
( Voice Memo > QSO Recorder > Recorder set >
RX REC Condition)
t Push [MENU] to exit the Menu screen.
NOTE: Even if you set File Split item to OFF, when the
recording file’s content becomes 2 GB, the transceiver
continues to record, but to a new file.
■ Record the transmit and receive audio into the same file
About the VOICE PLAYER screen when recording
into the same file
The VOICE PLAYER screen
shows information that is re-
corded first.
When the receive audio was
recorded first, the transmit
audio information is not dis-
played on the screen.
To Next Page
Loading...
Need help?
General
