8
D-STAR OPERATION <BASIC>
8-20
■ Reflector operation (Continued)
D Requesting repeater information
When you send the repeater information command, an
ID message is sent back.
q Hold down for 1 second.
• The DR screen appears.
w Push D-pad() to select “TO,” and then push D-
pad(Ent).
e Push D-pad() to select “Reflector,” and then push
D-pad(Ent).
• The “REFLECTOR” screen appears.
r Push D-pad() to select “Repeater Information.”
t PushD-pad(Ent).
• The transceiver returns to the DR screen.
• “Repeater Information” and “I” are displayed in “TO.”
y Hold down [PTT] to send the repeater information
command.
• The TX/RX indicator lights red.
u Release [PTT] to hear the repeater ID message.
To Next Page
Loading...
Need help?
General
