17
OTHER FUNCTIONS
17-3
■ Voice TX function (Continued)
D To transmit the recorded voice audio
q Push [MENU] .
w Push D-pad() to select the root item (“Voice TX”),
and then push D-pad(Ent).
e Push D-pad() to select “<<Single TX>>” or “<<Re-
peat TX>>,” and then push D-pad(Ent).
<<Single TX>>
The transceiver transmits the recorded voice audio
once.
<<Repeat TX>>
The transceiver repeatedly transmits the recorded
voice audio for up to 10 minutes at the interval speci-
fied in “Repeat Time.”
• The recorded voice audio is repeatedly transmitted for up
to 10 minutes. Even if 10 minutes pass while transmitting,
the voice audio is completely transmitted.
• One of the following will cancel the transmission.
- Push [PTT].
- Turn OFF the power, then turn it ON again.
- Push any key (except for [POWER]).
- Rotate [DIAL].
• Once the Repeat TX is sent, the transceiver pauses until
the end of the “Repeat Time,” then transmits again. After
the second transmission, the Repeat TX continues paus-
ing, if receiving a signal, even if the Busy Lockout is ON.
But if the squelch is manually opened in the FM mode,
the voice audio is repeatedly transmitted, according to
the repeat time setting.
r Push [MENU] to exit the MENU screen.
Blinks while
transmitting.
• Voice TX Waiting screen for <<Repeat TX>>
The Voice TX can be selected on the QUICK Menu
screen.
➥ Push [QUICK] , and then push D-pad() to se-
lect “Voice TX.”
To Next Page
Loading...
