8
D-STAR OPERATION <BASIC>
8-15
The destination repeater call sign can be directly input.
q Hold down for 1 second.
• The DR screen appears.
w Push D-pad() to select “TO,” and then push D-
pad(Ent).
e Push D-pad() to select “Direct Input (RPT).”
r Push D-pad(Ent) to enter the edit mode.
t Rotate [DIAL] to select a desired character.
(Example: J)
• A to Z, 0 to 9, / and a space can be selected.
• Rotate [DIAL] counterclockwise to enter a space.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously erase the characters,
first to the right, and then to the left of the cursor.
y Push D-pad() to move the cursor to the second
digit.
u Repeat steps t and y to enter a name of up to 8
characters, including spaces.
(Example: First, J, then P, then 3, then Y, then D,
then H.)
i After entering, push D-pad(Ent) twice.
• “JP3YDH” is displayed in “TO.”
• After entering, you can correct the call sign in the DI-
RECT INPUT (RPT) screen.
• The entered call sign remains on the DIRECT INPUT
(RPT) screen, until entering a new call sign.
The following settings are also correct.
The repeater node*
is input.
“/” is input.
In this case, the call sign is of
a repeater for a Gateway call.
* Although the repeater node letter is ‘B’ for 430 MHz band,
‘A’ is used in Japan. See page 8-1 for details.
TIP: If the entered call sign is duplicated in the Re-
peater List, the name is displayed. (Only when the
name has been entered.)
Example: Directly input the call sign “JP3YDH”
■ Setting “TO” (Destination) (Continued)
D Directly inputting (RPT)
Completed
[DIAL]
To Next Page
Loading...
Need help?
General
