13
SCAN OPERATION
13-13
This function temporarily skips unwanted frequencies
during a scan, for the set period.
This function enables you to temporarily skip the un-
wanted frequencies without the skip frequency setting.
q Start the scan. (pp. 13-5, 13-9)
• When a signal is received, the scan pauses.
w While the scan is paused, and if you want to skip the
frequency, push [QUICK] .
e Push D-pad() to select “Temporary Skip,” and then
push D-pad(Ent).
r After pushing D-pad(Ent), the scan resumes.
• The frequency will be skipped for the Temporary Skip
time period.
• After the Temporary Skip time period passes, or the scan
is cancelled, the Temporary Skip is also cancelled.
■ Setting the temporary skip function
Example: Full scan in the FM mode.
When a signal is received.
Blinks
Blinks
Blinks
Blinks
Push [QUICK]
.
Push D-pad() to
select, then push
D-pad(Ent).
TIP: During Memory or DR scanning, follow steps w
and r to skip the channel for the set period (Default:
5 minutes).
Up to 5 Temporary Skip fre-
quencies or memories can
be set.
When the 6th frequency or
memory is set, the pop up
screen appears as shown
to the right, and the oldest
frequency or memory is au-
tomatically deleted.
TIP: The Temporary Skip time period is set to “5 min-
utes” by default.
You can change the setting in the MENU screen.
(MENU > Scan > Temporary Skip Timer)
To Next Page
Loading...
Need help?
General
