Icom ID-51A User Manual

9
D-STAR OPERATION <ADVANCED>
9-24
This section describes how to manually enter new re-
peater information into the Repeater List.
The required setting items differ, depending on your
communication usage. Be sure to confirm the required
items, as shown below.
D Required items for the communication cases
Repeater List
contents
Used as an
access repeater
Used as a destina-
tion repeater
Used for DV
simplex
Used as an FM
repeater
Used for FM
simplex
TYPE
●
(DV Repeater)
●
(DV Repeater)
●
(DV Simplex)
●
(FM Repeater)
●
(FM Simplex)
NAME
    
SUB NAME
    
CALL SIGN
● ●
N/A

N/A
GW CALL SIGN
●
(For a Gateway call)
●
N/A N/A N/A
GROUP
    
USE(FROM)
●

● ● ●
FREQUENCY
●

● ● ●
DUP
●

N/A
●
N/A
OFFSET FREQ
●

N/A
●
N/A
MODE N/A N/A N/A
● ●
TONE N/A N/A N/A
●

RPT TONE N/A N/A N/A
●

POSITION
    
LATITUDE
    
LONGITUDE
    
UTC OFFSET
    
●: Must be entered
: Possible to enter
N/A: Not Available
■ Entering information into Repeater List
NOTE: To enter DV repeater information into the Re-
peater List, the repeater’s call sign MUST be entered.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)