11
VOICE MEMORY FUNCTION
11-2
■ Recording a QSO audio
You can record the audio of a QSO (communication) on
the MAIN band onto the microSD card.
In addition to both the received and transmitted audio,
the date, repeater, frequency and the destination call
sign are also recorded. This is convenient when you
write a QSL card or make an entry in a QSO log.
TIP: If you want to record only received audio, see
“Changing the recording mode” to change the record-
ing mode to “RX only.” (p. 11-10)
D To start recording
q Push [QUICK] to open the Quick Menu screen.
w Push D-pad() to select “<<REC Start>>.”
e Push D-pad(Ent) to start voice recording.
• The transceiver displays “Recording started” and auto-
matically exits the Quick Menu screen.
• “
” appears while the transceiver is recording.
• While in the stand-by mode, the recording is paused, and
“
” appears.
• Recording is continuous until you manually stop it, or the
card becomes full.
• If the recording file’s content reaches 2 GB, the trans-
ceiver automatically creates a new file, and continues
recording.
While recording
While pausing
Push [QUICK] .
Then, push D-pad() to
select.
Push D-pad(Ent) to start
voice recording
NOTE:
• BC Radio audio cannot be recorded.
• Once recording has started, the recording will con-
tinue, even the transceiver is turned OFF and then
ON again.
To Next Page
Loading...
