11
VOICE MEMORY FUNCTION
11-11
In the default settings, the transceiver records audio
only while receiving signals (the squelch opens).
If you want to continue recording even if no signal is
received, do the following steps.
q Push [MENU] to enter the Menu screen.
w Push D-pad() to select the root item (Voice Memo),
and then push D-pad(Ent) to go to the next level.
( MENU > Voice Memo > QSO Recorder > Recorder
Set > RX REC Condition)
e Refer to the menu sequence shown directly above
and push D-pad() to select, and then D-pad(Ent)
to enter, one or more times until the last screen is
displayed.
r Push D-pad() to select “Always,” and then push D-
pad(Ent) to save.
• Always: Recording continues, even if no signals
are received.
• Squelch Auto: The transceiver records audio only while
receiving signals (the squelch opens).
t Push [MENU] to exit the Menu screen.
■ Continue to record even if no signals are received
To Next Page
Loading...
Need help?
General
