Icom ID-51A

14
PRIORITY WATCH
14-10
■ VFO scan and Memory/Bank scan
Blinks
Example:
Sequentially c hecks the memory channels ev-
ery 5 seconds during a VFO scan.
Sequentially checks the Memory or Bank channels ev-
ery 5 seconds during a VFO scan.
1. Start the Memory or Bank scan
• To select a Memory scan
q Push [M/CALL]
to select the Memory mode.
w Hold down [SCAN] for 1 second.
e Push D-pad() to select the scan type, and
then push D-pad(Ent) to start the Memory scan.
(p. 13-9)
D-pad
()
(Ent)
• To select a Bank scan
q Push [M/CALL] to select the Memory mode.
w Hold down [SCAN] for 1 second.
e Push D-pad() to select the scan type, and
then push D-pad(Ent) to start the Bank scan.
(p.13-10)
How to select the Memory and Bank:
z In the Memory mode, push [QUICK]
.
x Push D-pad() to select “Bank Select,” and
then push D-pad(Ent).
• The Bank list is displayed.
c Push D-pad() to select a desired bank and
then push D-pad(Ent).
• If “OFF” is selected, the bank selection is can-
celed.
2. Start the Priority watch
q Push [QUICK]
.
w Push D-pad() to select “PRIO Watch,” and then
push D-pad(Ent).
e Push D-pad() to select “ON” or “Bell.”
• ON: When a signal is received on the priority
channel, the channel is automatically se-
lected.
• Bell: When a signal is received on the priority
channel, the “ ” icon is displayed in the
VFO mode.
r Push D-pad(Ent) to start the Priority watch.
• The “PRIO” icon appears
☞ Continued on the next page.
Push [M/CALL] .
Hold down [SCAN]
for 1 second.
Push D-pad() to
select, then push
D-pad(Ent).
Blinks
Push [QUICK]
.
Push D-pad() to
select, then push
D-pad(Ent).
Push D-pad() to
select, then push
D-pad(Ent).
Previous view