EasyManuals Logo

Icom ID-51A User Manual

Icom ID-51A
413 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #214 background imageLoading...
Page #214 background image
12
MEMORY OPERATION
12-10
Entering a memory/bank/scan name
q Hold down [S.MW] for 1 second to enter the Se-
lect Memory write mode.
• 1 short and 1 long beep sounds.
The memory channel number blinks.
DO NOT hold down [S.MW] for more than 2 seconds.
w Rotate [DIAL] to select a desired memory channel.
Select Call channels (C0 to C3) to program a Call chan-
nel name, or Scan edge channels (0A/0B to 24A/24B) to
program a scan name.
e Push [QUICK] to open the Quick Menu screen.
r Push D-pad() to select “Edit,” and then push D-
pad(Ent) to enter the name programming mode.
D-pad
()
(Ent)
t Push D-pad() to select “MNAME,“BNAME” or
“SNAME, and then push D-pad(Ent).
MNAME” is for a memory name, “BNAME” for a bank
name or “SNAME” for a scan name.
If the selected memory channel’s name has already been
programmed, the name is displayed.
“BNAME” appears only when the selected memory chan-
nel is assigned to a bank.
“SNAME” appears only when the selected memory chan-
nel is a scan edge channel. The same name is automati-
cally assigned to both scan edge channels, A and B.
After pushing D-pad(Ent), the cursor blinks on the first
digit.
[DIAL]
In the Select Memory
Write mode, select
M-CH000, and then
push [QUICK]
.
Push D-pad() to select
“Edit, and then push
D-pad(Ent).
Push D-pad() to select
“MNAME.
The cursor blinks on the
first digit.
Example: Programming the memory name “ID-51” in
M-CH000.
Each memory channel can be programmed with an al-
phanumeric channel name for easy recognition. Names
can be a maximum of 16 characters.
D Entering a memory name, bank name or scan name
Continued on the next page
NOTE: Only one name can be programmed for each
bank. Therefore, the previously programmed bank name
will be displayed when bank name is selected. Also, the
bank names are automatically updated in other memory
channels assigned to the same bank group.
NOTE: When entering the scan type selection mode,
the programmed Scan name is displayed instead of
the frequency range indication.
Previous view

Table of Contents

Other manuals for Icom ID-51A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom ID-51A and is the answer not in the manual?

Icom ID-51A Specifications

General IconGeneral
Frequency Range144-148 MHz, 430-450 MHz
Antenna ConnectorSMA
GPS ReceiverYes
WaterproofIPX7
ModesFM, DV
Weight255 g
Memory Channels1304 channels
Output Power5W (High), 2.5W (Middle), 0.5W (Low)

Related product manuals