9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-39
You can set unnecessary repeaters as scan skip tar-
gets. The selected repeaters are skipped during scan-
ning for faster selection and scanning.
You can set the skip setting to all repeaters in the se-
lected repeater group, or individual repeaters.
TIP: When a repeater is set as a skip target, its “USE
(FROM)” setting is automatically set to “NO.” In this
case, the repeater cannot be selected in “FROM” (Ac-
cess repeater).
D Individual skip setting
q Push [MENU] .
w Push D-pad() to select the root item (“DV Memo-
ry”), and then push D-pad(Ent).
e Push D-pad() to select “Repeater List,” and then
push D-pad(Ent).
r Push D-pad() to select the repeater group that in-
cludes the repeater you want to set the skip setting
on, and then push D-pad(Ent).
t Push D-pad() to select the repeater to be skipped
during the DR scan.
y Push [QUICK] .
u Push D-pad() to select “SKIP,” and then push D-
pad(Ent).
• “SKIP” appears on the selected repeater.
• Push [QUICK]
and select “SKIP” again, then push
D-pad(Ent) to cancel the skip setting.
• When “SKIP All ON” is selected, push D-pad(Ent) to set
all repeaters in the group as skip targets.
■ Skip settings for the DR scan
TIP: When you select “Re-
peater List” on the FROM
SELECT screen, you can
set the skip settings in the
same way as described
above.
Select the repeat-
er to set the skip
setting
Appears
Select the repeat-
er group.
To Next Page
Loading...
Need help?
General
