Icom ID-51A

12
MEMORY OPERATION
12-5
■ Copying memory and Call channel contents
This function copies a memory channel’s contents to
the VFO, another memory or Call channels. This is use-
ful when searching for signals around a memory chan-
nel frequency, and for recalling the frequency offset,
subaudible tone frequency and so on.
D Memory or Call channelVFO
q Select the Memory or Call channel to be copied.
➥ Push [M/CALL] one or more times to select
the Memory mode or the Call channel mode, then
rotate [DIAL] to select a desired channel.
w Hold down [S.MW] for 1 second to enter the
Select Memory write mode, and copy the memory
contents.
• 1 short and 1 long beep sounds.
• The memory channel number blinks.
e Rotate [DIAL] to select “VFO.”
r Hold down [S.MW]
for 1 second to copy the se-
lected channel contents to the VFO.
• The transceiver automatically returns to the VFO.
[DIAL]
Select the memory or call
channel to be copied.
Hold down [S.MW]
for 1 second to enter
the Select Memory write
mode, and then, rotate
[DIAL] to select “VFO.”
Hold down [S.MW]
for 1 second to copy.
The selected channel
contents appear in the
VFO screen.
NOTE: Holding down [S.MW] for 2 seconds in
step w will also copy the memory contents to the
VFO. In that case, steps e and r are not necessary.
Previous view