8
D-STAR OPERATION <BASIC>
8-17
■ Reflector operation (Continued)
D Linking to a reflector
If your repeater is not currently linked to a reflector, or
you want to change to another reflector, you can do so
following the steps below. Before linking to another re-
flector, be sure to unlink the current reflector.
Direct inputting
Example: Directly enter “REF010BL.”
q Hold down for 1 second.
• The DR screen appears.
w Push D-pad() to select “TO,” and then push D-
pad(Ent).
e Push D-pad() to select “Reflector,” and then push
D-pad(Ent).
• The “REFLECTOR” screen appears.
r Push D-pad() to select “Link to Reflector,” and then
push D-pad(Ent).
t Push D-pad() to select “Direct Input,” and then push
D-pad(Ent).
y Push D-pad() to select the reflector number.
(Example: 010)
u Push D-pad() to move the cursor.
i Push D-pad() to select module letter.
(Example: B).
o Push D-pad(Ent).
• The transceiver returns to the DR screen.
• “Link to Reflector” and “REF010BL” are displayed in
“TO.”
!0 Hold down [PTT] to link to the reflector.
• The TX/RX indicator lights red.
To Next Page
Loading...
