14
PRIORITY WATCH
14-8
Checks the selected priority channel every 5 seconds,
during a VFO mode scan.
1. Set the priority channel
• To select a Memory channel
q Push [M/CALL]
to select the Memory mode.
w Rotate [DIAL] to select the Memory channel you
want to watch.
• To select a Bank channel
q Push [M/CALL] to select the Memory mode.
w Rotate [DIAL] to select the Bank channel you
want to watch.
How to select the Memory and Bank:
z In the Memory mode, push [QUICK]
.
x Push D-pad() to select “Bank Select,” and
then push D-pad(Ent).
• The Bank list is displayed.
c Push D-pad() to select a desired bank and
then push D-pad(Ent).
• If “OFF” is selected, the bank selection is can-
celed.
• To select a Call channel
q Push [M/CALL] one or more times to select
the Call channel mode.
w Rotate [DIAL] to select the Call channel you want
to watch.
2. Start the Priority watch
q Push [QUICK]
.
w Push D-pad() to select “PRIO Watch,” and then
push D-pad(Ent).
e Push D-pad() to select “ON” or “Bell.”
• ON: When a signal is received on the priority
channel, the channel is automatically se-
lected.
• Bell: When a signal is received on the priority
channel, the “ ” icon is displayed in the
VFO mode.
r Push D-pad(Ent) to start the Priority watch.
• The “PRIO” icon appears.
3. Start the VFO scan
q Hold down [SCAN]
for 1 second.
w Push D-pad() to select the scan type, and then
push D-pad(Ent) to start the VFO scan. (p. 13-5)
■ VFO scan and a priority channel
Example: Checks memory channel “490”
every 5 sec-
onds,
during a VFO scan.
☞ Continued on the next page.
Push [M/CALL] ,
then rotate [DIAL] to se-
lect the Memory chan-
nel.
Push [QUICK] .
Push D-pad() to
select, then push
D-pad(Ent).
Push D-pad() to
select, then push
D-pad(Ent).
Hold down [SCAN]
for 1 second.
Push D-pad() to
select, then push
D-pad(Ent).
Blinks
Blinks
[DIAL]
NOTE: Push [CLR] to cancel both scans.
To Next Page
Loading...
