9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-34
■ Entering information into Repeater List
D New repeater entry (Continued)
15. Entering the UTC Offset
UTC (Universal Time Coordinated) offset is the time
difference between UTC and repeater local time. This
item enables you to check the destination repeater’s
time when you make a gateway call. (p. 9-42)
^0 Push D-pad() to select “UTC OFFSET,” and then
push D-pad(Ent) to enter the UTC offset edit mode.
^1 Rotate [DIAL] to enter the time difference between
UTC and the local time.
^2 After entering, push D-pad(Ent).
16. Storing the Repeater List
^3 Push D-pad(
) to select “<<Add Write>>,” and then
push D-pad(Ent).
^4 Push D-pad() to select “YES,” and then push D-
pad(Ent).
• The entered contents are stored to the Repeater List, and
the display returns to the RPT LIST screen.
To cancel the entered data:
To cancel the entered data,
push [CLR] to dis-
play “Cancel edit?.” Push
D-pad() to select “YES,”
and then push D-pad(Ent)
to cancel entering and the
display returns the RPT
LIST screen.
* “<<Overwrite>>” appears when “Edit” is selected
in [1. Repeater group selection].
Select
*
To Next Page
Loading...
Need help?
General
