Icom ID-51A User Manual

16
MENU SCREEN
16-9
NOTE: The default settings shown below are for the USA version.
The default settings may differ, depending on your transceiver version.
■ Menu items and Default settings (Continued)
In this item, set and display the call signs used in the DV mode.
This item displays the received call history in the DV mode.
UR: CQCQCQ, R1: --------, R2: --------, MY: --------
RX01:
This item stores Your Call signs or repeater information to use in the DV mode.
Your Call Sign
Repeater List* 01: ~ 30:
Blank
Call Sign
RX History
DV Memory
NOTE: The Repeater List described on this manual may differ from your preloaded list.
DESCRIPTIONS
DESCRIPTIONS
Displays the operating call signs.
Sets the operating call signs according to the
type of call you want to make.
Displays the calls your transceiver received.
Stores station call signs.
Adds or edits a call sign.
Stores repeater information.
Adds or edits a repeater information.
*
See page 9-47 for details of the preloaded data.
This item stores your own call sign to use in the DV mode.
My Call Sign 1: ~ 6:
TX Message 1: ~ 5: or OFF
My Station
RANGE OR VALUE (Default is shown in bold)
Stores your own call signs.
Select or edit a call sign to use in the DV mode.
Stores TX Messages.
Select or edit TX Message to use in the DV
mode.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)