Icom ID-51A User Manual

16
MENU SCREEN
16-29
■ Voice TX items (Continued)
Repeat Time (Default: 5sec)
Voice TX > TX Set > Repeat Time
Set the repeat interval to between 1 and 15 seconds (in 1 second steps).
The transceiver repeatedly transmits the recorded voice audio at this inter-
val.
NOTE: The recorded voice audio is repeatedly transmitted for up to 10
minutes. Even if 10 minutes passes while transmitting, the complete voice
audio is transmitted.
TX Monitor (Default: ON)
Voice TX > TX Set > TX Monitor
Turn the TX Monitor function ON or OFF.
• OFF: The TX voice audio is not heard from the speaker.
• ON: The TX voice audio is heard from the speaker.
<<Single TX>>
Voice TX > TX Set > <<Single TX>>
The transceiver transmits the recorded voice audio once.
• To cancel the voice transmission, push [CLR] .
TIP: You can transmit the recorded voice audio also from the QUICK MENU
screen. (p. 17-3)
<<Repeat TX>>
Voice TX > TX Set > <<Repeat TX>>
The transceiver repeatedly transmits the recorded voice audio for up to 10
minutes at the specified interval in the Repeat Time item.
• To cancel the voice transmission, push [CLR] .
TIP: You can transmit the recorded voice audio also from the QUICK MENU
screen. (p. 17-3)
NOTE:
• The recorded voice audio is repeatedly transmitted for up to 10 minutes.
Even if 10 minutes passes while transmitting, the complete voice audio is
transmitted.
• One of the following steps will cancel the transmission.
- Push [PTT].
- Turn OFF the power, then turn it ON again.
- Push any key (except for [POWER]).
- Rotate [DIAL].
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)