EasyManuals Logo

Intel Cyclone 10 GX User Manual

Intel Cyclone 10 GX
402 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #187 background imageLoading...
Page #187 background image
The following simulation flows are available:
NativeLinkThis flow simplifies simulation by allowing you to start a simulation
from the Quartus Prime software. This flow automatically creates a simulation
script and compiles design files, IP simulation model files, and Intel simulation
library models.
Note: The Quartus Prime Pro Edition software does not support NativeLink RTL
simulation
Scripting IP Simulation—In this flow you perform the following actions:
1. Run the ip-setup-simulation utility to generate a single simulation script that
compiles simulation files for all the underlying IPs in your design. This script
needs to be regenerated whenever you upgrade or modify IPs in the design.
2. You create a top-level simulation script for compiling your testbench files and
simulating the testbench. It will source the script generated in the first action.
You do not have to modify this script even if you upgrade or modify the IPs in
your design.
Custom Flow—This flow allows you to customize simulation for more complex
requirements. You can use this flow to compile design files, IP simulation model
files, and Intel simulation library models manually.
You can simulate the following netlist:
The RTL functional netlist—This netlist provides cycle-accurate simulation using
Verilog HDL, SystemVerilog, and VHDL design source code. Intel and third-party
EDA vendors provide the simulation models.
Prerequisites to Simulation
Before you can simulate your design, you must have successfully passed Quartus
Prime Analysis and Synthesis.
Related Information
Simulating Altera Designs
2.10.1. NativeLink Simulation Flow
The NativeLink settings available in the Quartus Prime software allow you to specify
your simulation environment, simulation scripts, and testbenches. The Quartus Prime
software saves these settings in your project. After you specify the NativeLink
settings, you can start simulations easily from the Quartus Prime software.
2. Implementing Protocols in Intel Cyclone 10 GX Transceivers
UG-20070 | 2018.09.24
Send Feedback
Intel
®
Cyclone
®
10 GX Transceiver PHY User Guide
187

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intel Cyclone 10 GX and is the answer not in the manual?

Intel Cyclone 10 GX Specifications

General IconGeneral
BrandIntel
ModelCyclone 10 GX
CategoryTransceiver
LanguageEnglish

Related product manuals