d When the last of the 16 values is entered and becomes solid, TPS Right 17-32 or TPS Left
17-32 appears.
e Continue entering and pausing
4 After the 32nd number is entered and becomes solid, the number is automatically entered.
• If the number is incorrect, then Checksum does not match appears, and the original screen appears to
reenter the value.
If the number is correct, then Saving changes to NVRAM appears.
TPS Setup: Cal Ref Adj
The Cal Ref Adj is used with Reset Color Cal, which resets to a default value, Cal Ref Adj allows you to fine tune the TPS
function.
To set the Cal Ref Adj:
1 Select TPS Setup from Diag Menu, and press Select.
2 Select Cal Ref Adj, and press Select.
3 Select CMY or Black, and press Select.
4 Press Left to decrease or Right to increase the value.
The values can be -8 to +8, and the default value is 0.
5 To cancel and return to the menus, press Back.
TPS Setup: Reset Color Cal
This setting allows the device to adjust the alignment of the color planes using pre-programmed default values.
To reset the programmed value:
1 Select TPS Setup from Diag Menu, and press Select.
2 Select Reset Color Cal, and press Select.
Resetting appears. When the reset is complete, the screen is automatically returned to TPS Setup.
Reports: Menu Settings Page
To print the Menu Settings Page:
1 Select Reports from Diag Menu, and press Select.
2 Select Menu Settings Page, and press Select.
7527
Service menus
209
To Next Page
Loading...
Need help?
General
