95y errors
95y error messages
Error code Description Action
950.xx There is a mismatch between controller
EEPROM and mirror.
• 950.00 through 950.29 codes: mismatch
between controller and mirror
• 950.30 through 950.60 codes: mismatch
between secure and controller
Go to
“950.xx NVRAM failure service check”
on page 114.
951.xx Error NV part on system board. Go to
“Controller board removal” on
page 309.
952.xx A recoverable MVRAM Cyclic Redundancy Check
(CRC) error occurred. n is the offset at which the
error occurred.
Performing a POR will clear this error.
953.xx (CX310 - CX410)
NVRAM chip failure with mirror.
1 POR the printer.
2 If the problem persists, replace the UICC
card.
Go to
“Operator panel removal (for CX310
and CX410 models only)” on page 276.
953.xx (CX510)
NVRAM chip failure with mirror.
1 POR the printer.
2 If the problem persists, replace the UICC
card.
Go to
“Operator panel removal (for CX510
models only)” on page 283.
7527
Diagnostic information
113
To Next Page
Loading...
