Lexmark CX310 - Toner Meter Cycle (TMC) Card Removal

3 Remove the two screws (C).
4 Remove the fuser drive motor assembly.
Toner meter cycle (TMC) card removal
1 Remove the imaging unit. See “Imaging unit (IU) removal” on page 267.
2 Remove the rear cover. See “Rear cover removal” on page 307.
3 Disconnect the TMC cable from JCTM1 connector (A), and push the toner meter cycle card cable through the frame
opening.
Note: Pay close attention to the routing of the cable for reinstallation.
7527
Repair information
258