4 Disconnect the waste toner bottle contact block (B) from the controller board.
5 Remove the waste toner bottle contact block.
Front removals
Front cover assembly removal
1 Remove the media tray.
2 Open the front cover.
3 Remove the front middle cover (optional). See “Front middle cover removal” on page 275.
4 Remove the five screws (A) from the cable cover.
5 Remove the cable cover.
6 Remove the screw (B) securing the right restraining strap to the front cover.
Note: Support the door with one hand after removing the screw holding the restraining strap. This is the longest
screw of the eight. The two flat‑head Phillips screws are used in the door hinge.
7527
Repair information
273
To Next Page
Loading...
