Action for prompts
This setting enables users to determine which input source would receive paper-related or envelope-related change
prompts when they occur. Regardless of the target source, the device always requires some type of user assistance to
resolve the change prompt (examples: pushing a button to ignore the prompt and changing the source’s installed
media). However, this setting gives a user the option of having the device resolve change prompt situations without
requiring any user assistance.
To change this setting:
1 From the Configuration Menu, navigate to Action for prompts.
2 Touch Left or Right to change the setting.
3 Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any changes.
When set to Prompt user, the device behaves like the past implementation. When a change prompt occurs, the device
stops printing, posts the change prompt to the target source, and waits for the user to select an action before continuing.
When set to Continue, the device automatically assumes that the user selects Continue every time a change prompt
is encountered. Likewise, when the device is set to Use Current, all change prompts will perform as if Use Current was
selected by the user.
ADF Edge Erase
The value of this setting determines the size in millimeters of the “no-print” zone around an ADF scan job.
To change this setting:
1 From the Configuration Menu, navigate to ADF Edge Erase.
2 Touch Left or Right to change the setting.
3 Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any changes.
Size sensing
B5/Executive
Due to engine limitations, Trays 1 through 4 cannot simultaneously sense executive and JIS-B5-size paper. The value
of this setting determines which of the two paper sizes these trays will sense automatically. This setting will apply to
all automatic trays, but not to the MP Feeder. The MP Feeder can support these paper sizes regardless of the value of
this setting.
Tray [x] sensing
By turning the tray [x] sensing setting to Auto, every input option equipped with size sensing hardware automatically
registers what size of paper it contains. When this setting is turned Off, the printer ignores the size detected by the
hardware and treats the input source as a non-sensing source. The media size can be set by the operator panel or the
data stream.
7527
Service menus
217
To Next Page
Loading...
Need help?
General
