To run the Flash Test:
1 Select DEVICE TESTS from Diag Menu, and press Select.
2 Select Flash Test, and press Select.
Contents will be lost. Continue? appears.
3 To continue, select Yes, and press Select. To end the test, select No, and press Select.
If you continue, Flash Test Testing… appears.
• If the test is successful, then Flash Test Test Passed appears. Use Format Flash in the Utilities Menu
to reformat the flash card
• If the test is unsuccessful, then Flash Test Test Failed appears. Replace the flash card.
4 Press Back to remove the message and return to the Device Tests menu.
PRINTER SETUP
• “Defaults” on page 205
• “PAGE COUNTS” on page 206
• “Serial Number” on page 206
• “Engine Setting 1 through 4” on page 206
• “Model Name” on page 206
• “Configuration ID” on page 206
• “Transfer Module Barcode” on page 207
• “Reset Fuser Count” on page 207
Defaults
This setting is used by the printer to determine whether US or non-US factory default values should be used. The
following printer settings have different US and non-US values:
Printer default values US value Non-US value
Paper Sizes setting in the General Settings menu U.S. Metric
Default Paper Size (paper feeding sources which do not
have hardware size sensing capabilities)
Letter A4
Default Envelope Size (envelope feeding sources which do
not have hardware size sensing capability)
10 Envelope DL Envelope
Fax media size Letter A4
PCL Symbol Set PC-8 PC-850
PPDS Code Page 437 850
Universal Units of Measure Inches Millimeters
Warning—Potential Damage: Modification of the printer setting Defaults causes the NVRAM space to be restored to
the printer’s factory settings.
7527
Service menus
205
To Next Page
Loading...
