The printed event log can be faxed to your next level of support for verification or diagnosis.
To print the event log:
1 Select Event Log from Diag Menu, and press Select .
2 Select Print Log, and press Select.
3 Press Back to return to Event Log.
Clear Log
Use Clear Log to remove the current information in the Event Log. This affects both the viewed log and the printed log
information.
To clear the event log:
1 Select Event Log from Diag Menu, and press Select .
2 Select Clear Log, and press Select.
3 Select YES to clear the Event Log or NO to exit the Clear Log menu. If YES is selected, the Deleting EVENT
LOG displays on the screen.
4 Press Back to return to Event Log.
Scanner tests
• “ASIC Test” on page 211
• “Motor tests” on page 211
• “Feed test” on page 212
• “Sensor tests” on page 212
• “Scanner calibration reset” on page 215
• “ADF magnification” on page 215
ASIC Test
This setting initiates a scan of the scanner ASIC’s memory.
To perform this test, do the following:
1 Navigate to Scanner Tests > ASIC Test.
2 The test executes. While this test executes, the screen displays ASIC Test Running.... If the scanner ASIC
passed the test, then the panel posts ASIC Test Passed. Rebooting.... If the scanner ASIC failed the
test, then the panel posts ASIC Test Failed. Rebooting....
Motor tests
ADF pick
When Motor On is selected, the device runs the pick motor continuously for five seconds and then automatically stops
the motor.
7527
Service menus
211
To Next Page
Loading...
Need help?
General
