8 Remove the ground screw (F), and disconnect the four cables (G) and the ribbon cable (H.)
Note: Disconnect the ribbon cable by using a screwdriver to pull the pivot (I) out and rotate up. See “Ribbon
cable connectors” on page 232 for the proper way to handle ribbon cables.
Note: After replacing this part, a scanner manual registration must be performed. See “Scanner manual
registration” on page 222. A scanner calibration reset must also be performed. See “Scanner calibration reset”
on page 215.
Installation note: To install the ribbon cable, rotate the latch down and push it back into the connector. Be
careful to not damage the latch.
7527
Repair information
336
To Next Page
Loading...
