Lexmark T652 - Page 117

242 error messages
Error code Description Action
242.00 Media tray 2 area jam
The media is jammed in the media tray 2 area.
Go to
“Tray area jam service check” on
page 125.
242.02 Sensor (pass through) late jam (tray 2)
The media is late reaching the sensor (pass
through) within the specified time.
Go to
“Sensor (pass through) late jam service
check” on page 98.
242.03 Sensor (pass through) late jam (tray 2)
The media is late reaching the sensor (pass
through) within the specified time.
242.04 Sensor (pass through) late jam (tray 2)
The media is late reaching the sensor (pass
through) within the specified time.
242.05 Sensor (pass through) late jam (tray 2)
The media is late reaching the sensor (pass
through) within the specified time.
242.06 Sensor (pass through) late jam (tray 2)
The media is late reaching the sensor (pass
through) within the specified time.
242.08 Sensor (pass through) lingering jam (tray 2)
Media reached the sensor (pass through) within
the specified time, but did not clear it within the
specified
time.
Go to
“Sensor (pass through) lingering jam
service check” on page 125.
242.09 Sensor (input) late jam (tray 2)
The media is late reaching the sensor (input)
within the specified time.
Go to
“Sensor (pass through) late jam service
check” on page 98.
242.10 Sensor (pass through) late jam (tray 2)
The media is late reaching the sensor (pass
through) within the specified time.
Go to
“Sensor (pass through) late jam service
check” on page 98.
242.13 Sensor (pass through) static jam (tray 2)
Media remains on the sensor (input) during the
warm-up sequence.
Go to
“Sensor (pass through) static jam
service check” on page 127.
242.16 Sensor (pass through) late jam (tray 2)
The media is late reaching the sensor (pass
through) within the specified time.
Go to
“Sensor (pass through) late jam service
check” on page 98.
242.17 Media tray pulled jam (tray 2)
A media tray above the source tray was pulled
during the printing process.
Go to
“Media tray pulled jam service check”
on page 129.
242.18 Pick retry timeout (tray 2)
Restart the printer.
N/A
242.19 Pick retry timeout (tray 2)
Restart the printer.
4062
Diagnostic information
117