7.2.3 Setting Operation Command and Frequency ......................... 353
7.2.4 Command Loss Protective Operation ..................................... 353
7.3 LS INV 485/Modbus-RTU Communication ......................................... 356
7.3.1 Setting Virtual Multi-function Input ........................................... 356
7.3.2 Saving Parameters Defined by Communication .................... 356
7.3.3 Total Memory Map for Communication ................................... 357
7.3.4 Parameter Group for Data Transmission ................................ 358
7.3.5 Parameter Group for User/Macro Group ................................ 359
7.3.6 LS INV 485 Protocol ................................................................. 360
7.3.7 Modbus-RTU Protocol .............................................................. 366
7.3.8 Compatible Common Area Parameter .................................... 370
7.3.9 H100 Expansion Common Area Parameter ........................... 374
7.4 BACnet Communication ....................................................................... 389
7.4.1 What is BACnet Communication? ........................................... 389
7.4.2 BACnet Communication Standards ........................................ 389
7.4.3 BACnet Quick Communication Start ....................................... 390
7.4.4 Protocol Implementation........................................................... 392
7.4.5 Object Map ................................................................................ 393
7.5 Metasys-N2 Communication ................................................................ 400
7.5.1 Metasys-N2 Quick Communication Start ................................ 400
7.5.2 Metasys-N2 Communication Standard ................................... 400
7.5.3 Metasys-N2 Protocol I/O Point Map ........................................ 402
8 Table of Functions.......................................................................................... 406
8.1 Drive Group (DRV) ................................................................................ 406
8.2 Basic Function Group (BAS) ................................................................ 410
8.3 Expanded Function Group (ADV) ........................................................ 415
8.4 Control Function Group (CON) ............................................................ 423
8.5 Input Terminal Group (IN) ..................................................................... 426
8.6 Output Terminal Block Function Group (OUT) .................................... 434
8.7 Communication Function Group (COM) .............................................. 440
8.8 Advanced Function Group(PID Functions) ......................................... 447
8.9 EPID Function Group (EPID) ............................................................... 459
8.10 Application 1 Function Group (AP1) .................................................... 467
8.11 Application 2 Function Group (AP2) .................................................... 473
8.12 Application 3 Function Group (AP3) .................................................... 479
8.13 Protection Function Group (PRT)......................................................... 486
8.14 2nd Motor Function Group (M2) ........................................................... 496
8.15 Trip (TRIP Last-x) and Config (CNF) Mode ......................................... 498
8.15.1 Trip Mode (TRP Last-x) ............................................................ 498
8.15.2 Config Mode (CNF) .................................................................. 500
To Next Page
Loading...
Need help?
General
