LSIS LSLV0055H100-4COFN - Parameter Setting Mode

Learning to Perform Basic Operations
56
Parameter Setting Mode
The following table lists the functions groups under Parameter mode.
Function Group Name
Keypad Display
Description
Drive
DRV
Configures basic operation parameters. These
include jog operation, motor capacity evaluation, and
torque boost.
Basic
BAS
Configures basic operation parameters. These
parameters include motor parameters and multi-step
frequency parameters.
Advanced
ADV
Configures acceleration or deceleration patterns,
frequency limits, energy saving features, and,
regeneration prevention features.
Control
CON
Configures the features related to speed search and
KEB (kinetic energy buffering).
Input Terminal
IN
Configures input terminal–related features, including
digital multi–functional inputs and analog inputs.
Output Terminal
OUT
Configures output terminal–related features,
including digital multi–functional outputs and analog
outputs.
Communication
COM
Configures the USB-related features and
communication features for the RS-485, Modbus-
RTU, LS Bus, Metasys N2, and BACnet. Optional
communication module related features may be
configured as well, if one is installed.
PID process
PID
Configures the PID control-related features.
EPID process
EPI
Configures the external PID control-related features.
Application 1
AP1
Configures the Sleep Boost, SoftFill, and Multiple
motor control (MMC) features related to the PID
control.
Application 2
AP2
Configures the HVAC features by setting the features
such as load tuning, pump cleaning, and pay back
counter.
Application 3
AP3
Configures the time event-related features.
Protection
PRT
Configures motor and inverter protection features.
Motor 2 (Secondary
motor)
M2
Configures the secondary motor-related features.