Learning Advanced Features
AP1-61
AP1-62
AP1-63
AP1-64
AP1-65
Max Freq
Frequency
AP1-71
AP1-72
Aux Motor 1
Aux Motor 2
Aux Motor 3
Aux Motor 4
Aux Motor 5
Feedback
AP1-71
AP1-72
Perform Main_Exch
Reset the [Auto Op Time]
AP1-62
AP1-63
0%
100%
Fx
Off
On
Stop
Run
Inv State
Main Motor
Main Motor
5min
10min
30min
Operation time
M1(30min) / M2(25min) /
M3(20min)
Priority at the moment
M1 M2 M3 /
M4 M5
Priority at the moment
M1 M3 M2 /
M4 M5
Priority at the moment
M4 M5 M3 /
M2 M1
Supposing its operation in
less than 1minute
AP1-65
AP1-
74
Motor to operate MMC : M1, M2, M3
Standby motor : M4, M5
Motor to operate MMC : M3, M4, M5
Standby motor : M1, M2
AP1-72
Main Auto Change operation (Op Time Order) when Operable Motor and Standby Motor are set to 3 and 2 each
Option 3: AP1-91: [Interlock DT]
5.44.4 Interlock
When there is motor trouble, the interlock feature is used to stop the affected motor and
replace it with another that is not currently operating (off state). To activate the interlock
feature, connect the cables for abnormal motor signal to the inverter input terminal and
configure the terminals as interlock 1–5 inputs. Then, the inverter decides the motor‘s
To Next Page
Loading...
