LSIS LSLV0055H100-4COFN - Switching between the Operation Modes (HAND; AUTO; OFF)

Learning Basic Features
78
Basic Tasks
Description
Ref.
slows down and stops.
Power braking
Configures the inverter to provide optimal, motor
deceleration, without tripping over-voltage protection.
p.132
Start/maximum frequency
configuration
Configures the frequency reference limits by defining a
start frequency and a maximum frequency.
p.133
Upper/lower frequency limit
configuration
Configures the frequency reference limits by defining
an upper limit and a lower limit.
p.133
Frequency jump
Configures the inverter to avoid running a motor in
mechanically resonating frequencies.
p.136
2
nd
Operation Configuration
Used to configure the 2
nd
operation mode and switch
between operation modes according to your
requirements.
p.137
Multi-function input terminal
control configuration
Enables the user to improve the responsiveness of the
multi-function input terminals.
p.139
4.1 Switching between the Operation Modes (HAND /
AUTO / OFF)
The H100 series inverters have two operation modes–the HAND and AUTO modes. HAND
mode is used for local control using the keypad. AUTO mode is used for remote control
using the terminal inputs or networks commands (the keypad may still be used in AUTO
mode if the command source is set as ‗keypad‘).
HAND Mode Operation
Follow the instructions listed below to operate the inverter in HAND mode.
1 On the keypad, use the [Up], [Down], [Left], or [Right] keys to set the frequency
reference.
2 Press the [HAND] key. The HAND LED turns on and the inverter starts operating in
HAND mode.
3 Press the [OFF] key. The OFF LED turns on and the inverter stops operating.