LSIS LSLV0055H100-4COFN - Terminal Block as a Command Input Device (Run and Rotation Direction Commands)

Learning Basic Features
104
4.6.3 Terminal Block as a Command Input Device (Run and
Rotation Direction Commands)
Multi-function terminals can be selected as a command input device. This is configured by
setting DRV-06 (command source) in the Drive group to 2(Fx/Rx-2). Select 2 terminals for
run and rotation direction commands, and then select the relevant codes (2 of the 5 multi-
function terminal codes, IN-65–71 for P1–P7) to 1 (Fx) and 2 (Rx) respectively. This
application uses an Fx input as a run command, and an Rx input to change a motor‘s
rotation direction (On: Rx, Off: Fx).
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
DRV
06
Command
source
Cmd
Source
2
Fx/Rx-2
0–5
-
IN
65–
71
Px terminal
configuration
Px Define
(Px: P1 –
P7)
1
Fx
0–55
-
2
Rx
Run Command and Fwd/Rev Change Command Using Multi-function Terminal –
Setting Details
Code
Description
DRV-06 Cmd Source
Set to ‗2 (Fx/Rx-2)'.
IN-65–71 Px Define
Assign a terminal for run command (Fx).
Assign a terminal for changing rotation direction (Rx).