4 Learning Basic Features
This chapter describes the basic features of the H100 inverter. Check the reference page in
the table to see the detailed description for each of the advanced features.
Operation mode selection
(HAND / AUTO / OFF)
Used to select the operation mode.
Frequency reference
source configuration for the
keypad
Configures the inverter to allow you to setup or modify
a frequency reference using the Keypad.
Frequency reference
source configuration for the
terminal block (input
voltage)
Configures the inverter to allow input voltages at the
terminal block (V1, V2) and to setup or modify a
frequency reference.
Frequency reference
source configuration for the
terminal block (input
current)
Configures the inverter to allow input currents at the
terminal block (I2) and to setup or modify a frequency
reference.
Frequency reference
source configuration for the
terminal block (input pulse)
Configures the inverter to allow input pulse at the
terminal block (TI) and to setup or modify a frequency
reference.
Frequency reference
source configuration for
RS-485 communication
Configures the inverter to allow communication signals
from upper level controllers, such as PLCs or PCs, and
to setup or modify a frequency reference.
Frequency control using
analog inputs
Enables the user to hold a frequency using analog
inputs at terminals.
Motor operation display
options
Configures the display of motor operation values.
Motor operation is displayed either in frequency (Hz) or
speed (rpm).
Multi-step speed
(frequency) configuration
Configures multi-step frequency operations by
receiving an input at the terminals defined for each step
frequency.
Command source
configuration for keypad
buttons
Command source configuration for keypad buttons.
Command source
configuration for terminal
block inputs
Configures the inverter to accept inputs at the FX/RX
terminals.
To Next Page
Loading...
