Learning to Perform Basic Operations
3.3 Fault Monitoring
3.3.1 Monitoring Faults during Inverter Operation
The following example shows how to monitor faults that occurred during inverter operation.
• If a fault trip occurs during inverter operation, the
inverter enters Trip mode automatically and displays
the type of fault trip that occurred.
• Press the [Down] key to view the information on the
inverter at the time of fault, including the output
frequency, output current, and operation type.
• If there were any fault trips that occurred previously,
press the [Right] key to display the fault trip
information at the times of previous fault trips.
• When the inverter is reset and the fault trip is
released, the keypad display returns to the screen it
was at when the fault trip occurred.
To Next Page
Loading...
