LSIS LSLV0055H100-4COFN - Setting Frequency Reference

83
Learning Basic Features
Use caution when the inverter is set to operate in AUTO mode by commands over
communication, and if COM-96 (PowerOn Resume) is set to ‗yes‘, as the motor will begin
rotating when the inverter starts up, without additional run commands.
4.2 Setting Frequency Reference
The H100 inverter provides several methods to setup and modify a frequency reference for
an operation. The keypad, analog inputs [for example voltage (V1, V2) and current (I2)
signals], or RS-485 (digital signals from higher-level controllers, such as PC or PLC) can be
used.
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
DRV
7
Frequency
reference
source
Freq Ref Src
0
KeyPad-1
0–11
-
1
KeyPad-2
2
V1
4
V2
5
I2
6
Int 485
7
Field Bus
9
Pulse
10*
V3
11
I3
* ‗10(V3)~11(I3)‘ of DRV-07 are available when Extension IO option is equipped. Refer to
Extension IO option manual for more detailed information.