Learning to Perform Basic Operations
• Press the [PROG/ENT] key to save the selection.
• The setting is saved and the code is displayed
again.
• Press the ESC key to go back to the initial code of
the Drive group (DRV-00).
3.2.7 Parameter Settings available in Monitor Mode
The H100 inverter allows basic parameters, such as the frequency reference, to be
modified in Monitor mode. When the inverter is in Hand or OFF mode, the frequency
reference can be entered directly from the monitor screen. When the inverter is in AUTO
mode, press the [PROG/ENT] key to access the input screen for a frequency reference.
Parameter setting in HAND/OFF mode
• Ensure that the cursor is at the frequency reference
item. If not, move the cursor to the frequency
reference item.
• When the cursor is at the frequency reference item,
detailed information is displayed and the cursor
flashes at the input line. A flashing cursor indicates
that it is waiting for user input.
• Press the [Left] or [Right] key to change places.
To Next Page
Loading...
