Learning to Perform Basic Operations
• Press the [Up] or [Down] keys to increase or
decrease the numbers, and then press the
[Prog/ENT] key to save the change.
Parameter setting in AUTO mode
• Ensure that the cursor is at the frequency reference
item. If not, move the cursor to the frequency
reference item.
• While the cursor is at the frequency reference monitor
item, press the [PROG/ENT] key to edit the frequency
reference.
• Detailed information is displayed and the cursor
flashes at the input line. A flashing cursor indicates
that it is waiting for user input.
• Press the [Left] or [Right] key to move the cursor.
• Press the [Up] or [Down] key to increase or decrease
the numbers.
• When you are done changing the frequency
reference, press [PROG/ENT] key to finish setting the
parameters.
• The newly entered frequency reference is displayed.
To Next Page
Loading...
