LSIS LSLV0055H100-4COFN - Jog Operation 2-Forward;Reverse Jog by Multi-Function Terminal

Learning Advanced Features
150
Code
Description
DRV-11 JOG
Frequency
Set the operation frequency.
DRV-12 JOG Acc
Time
Set the acceleration speed.
DRV-13 JOG Dec
Time
Set the deceleration speed.
If a signal is entered at the jog terminal while an FX operation command is on, the operation
frequency changes to the jog frequency and the jog operation begins.
5.2.2 Jog Operation 2-Forward/Reverse Jog by Multi-function
Terminal
For jog operation 1, an operation command must be entered to start operation, but while
using jog operation 2, a terminal that is set for a forward or reverse jog also starts an
operation. The priorities for frequency, Acc/Dec time and terminal block input during
operation in relation to other operating modes (Dwell, 3-wire, up/down, etc.) are identical to
jog operation 1. If a different operation command is entered during a jog operation, it is
ignored and the operation maintains the jog frequency.
Group
Code
Name
LCD Display
Parameter setting
Setting Range
Unit
DRV
11
Jog frequency
JOG
Frequency
10.00
0.00, Low Freq–
High Freq
Hz
12
Jog operation
acceleration time
JOG Acc
Time
20.00
0.00–600.00
sec
13
Operation
JOG Dec
30.00
0.00–600.00
sec