Learning to Perform Basic Operations
• The Basic group (BAS) is displayed.
• Press the [Up] or [Down] key to move to the desired
codes and configure the inverter functions.
3.2.6 Navigating Directly to Different Codes
Parameter mode, User & Macro mode, and Config mode allow direct jumps to specific
codes. The code used for this feature is called the Jump Code. The Jump Code is the first
code of each mode. The Jump Code feature is convenient when navigating for a code in a
function group that has many codes.
The following example shows how to navigate directly to code DRV- 09 from the initial code
(DRV-00 Jump Code) in the Drive group.
• The Drive group (DRV) is displayed in Parameter
mode. Make sure that the fist code in the Drive
group (DRV 00 Jump Code) is currently selected.
• Press the [PROG/ENT] key.
• The Code input screen is displayed and the cursor
flashes. A flashing cursor indicates that it is waiting
for user input.
• Press the [Up] key to increase the number to 16,
and then press the [PROG/ENT] key to jump to
code DRV-16.
• DRV-16 (Fwd boost) is displayed.
• Press the [MODE] key to view the options available
and use the [Up] or [Down] key to move to a desired
option.
To Next Page
Loading...
