Learning to Perform Basic Operations
• Press the [MODE] key to go back to Monitor mode.
The third display item has been changed to the
inverter output power (kW).
3.2.9 Selecting the Status Bar Display Items
On the top-right corner of the display, there is a monitoring display item. This monitoring
item is displayed as long as the inverter is turned on, regardless of the mode the inverter is
operating in. Configure this monitoring item to display the type of information that suits your
needs.
This item can be configured only when the inverter is operating in AUTO mode. In HAND or
OFF mode, this monitoring item displays frequency reference only.
The following example shows how to configure this monitoring item in AUTO mode.
• Monitor mode is displayed.
• On the top-right edge of the display, the frequency
reference is displayed (factory default).
• Enter Config mode and go to CNF-20 to select the
items to display.
• Press the [PROG/ENT] key. The currently selected
item is highlighted.
To Next Page
Loading...
