Learning to Perform Basic Operations
User & Macro Mode
Used to put the frequently accessed function
parameters together into a group. User parameter
groups can be configured using the multi-function
key on the keypad.
Provides different factory-preset groups of functions
based on the type of load.
Groups MC1, MC2, or MC3 is displayed when the
user selects the type of desired load. Macro groups
can be selected in CNF mode.
3.2 Learning to Use the Keypad
The keypad enables movement between groups and codes. It also enables users to select
and configure functions. At code level, you can set parameter values to turn specific
functions on or off or decide how the functions will be used. For detaled information on the
codes in each function group, refer to 8 Table of Functions on page 406. Confirm the
correct values (or the correct range of the values), then follow the examples below to
configure the inverter with the keypad.
3.2.1 Display Mode Selection
The following figure illustrates how the display modes change when you press the [Mode]
button on the keypad. You can continue to press the [Mode] key until you get to the desired
mode.
To Next Page
Loading...
