Learning to Perform Basic Operations
3.4 Parameter Initialization
The following example demonstrates how to revert all the parameter settings back to the
factory default (Parameter Initialization). Parameter initialization may be performed for
separate groups in Parameter mode as well.
• Monitor mode is displayed.
• Press the [MODE] key to move to the Config (CNF)
mode.
• Press the [Down] key to go to CNF-40 (Parameter
Init).
• Press the [PROG/ENT] key to configure the
parameter initialization options.
• In the list of options, select ‗1(All Grp),‘ and then
press the [PROG/ENT] key to perform parameter
initialization.
• The parameter initialization option is displayed again
when the initialization is complete.
To Next Page
Loading...
