Learning to Perform Basic Operations
3.2.5 Navigating through the Codes (Functions)
Code Navigation in Monitor mode
The display items in Monitor mode are available only when the inverter is in AUTO mode. In
Monitor mode, press the [Up] or [Down] key to move the cursor up or down. Different values,
such as the operating frequency, the output current, or voltage are displayed according to
the cursor position. The cursor does not move up or down in HAND mode or in OFF mode.
• In AUTO mode, the cursor appears to the left of the
frequency information.
• Press the [Down] key.
• Information about the second item in Monitor mode
(Output Current) is displayed.
• Wait for 2 seconds until the information on the display
disappears.
• Information about the second item in Monitor mode
(Output Current) disappears and the cursor
reappears to the left of the second item.
• Press the [Down] key.
• Information about the third item in Monitor mode
(Output Voltage) is displayed.
• Wait for 2 seconds until the information on the display
disappears.
• Information about the third item in Monitor mode
(Output Voltage) disappears and the cursor appears
to the left of the third item.
• Press the [Up] key twice.
To Next Page
Loading...
