Learning to Perform Basic Operations
• Information about the first item in Monitor mode
(Frequency) is displayed.
• Wait for 2 seconds until the information on the display
disappears.
• Information about the first item in Monitor mode
(Frequency) disappears and the cursor appears to
the left of the first item.
• Press the [Up] or [Down] key to move to a desired
item and view the information.
Code Navigation in Parameter mode
The following examples show you how to move through codes in different function groups
(Drive group and Basic group) in Parameter mode. In Parameter mode, press the [Up] or
[Down] key to move to the desired functions.
• Display turns on when the inverter is powered on.
Monitoring mode is displayed.
• Press the [MODE] key.
• Drive group (DRV) in Parameter mode is displayed.
The first code in the Drive group (DRV 00 Jump
Code) is currently selected.
• If any other group is displayed, press the [MODE] key
until the Drive group is displayed, or press the [ESC]
key.
• Press the [Down] key to move to the second code
(DRV 01) of the Drive group.
• Press the [Right] key to move to the next function
group.
To Next Page
Loading...
