LSIS LSLV0055H100-4COFN - Switching between Groups in User & Macro Mode

Learning to Perform Basic Operations
62
• The Drive group is selected again.
3.2.4 Switching between Groups in User & Macro Mode
User & Macro mode is accessible only when the user codes are registered or when the
macro features are selected. Refer to 8.16 Macro Groups on page 505 for details about
user code registration or macro group selection. After registering the user codes, or
selecting a macro group, follow the examples below to access the User & Macro group.
• Monitor mode is displayed on the keypad.
• Press the [MODE] key twice.
• User (USR) group in User & Macro mode is
displayed.
• Press the [Right] key.
• The Macro (MC2) group in User & Macro mode is
displayed.
• Press the [Right] key.
• User (USR) group in User & Macro mode is displayed
again.