AUTO Mode Operation
Follow the instructions listed below to operate the inverter in AUTO mode.
1 Press the [AUTO] key to switch to AUTO mode.
2 Operate the inverter using the terminal block input, commands via communication, or
keypad input.
3 Press the [OFF] key. The OFF LED turns on and the inverter stops operating.
Mode Keys and LED Status
Used to enter the HAND operation mode.
Used to enter the OFF mode (standby mode) or to reset fault trips.
Used to enter the AUTO operation mode or to start or stop inverter operation
in AUTO mode.
Turns on green (steady) during HAND mode operation.
Turns on red (steady) while the inverter is in OFF mode (standby), and flashes
then a fault trip occurs. The LED turns on red (steady) again when the fault trip
condition is released.
Turns on green (steady) when the inverter operates in Auto mode, and flashes
green when the inverter is in AUTO mode, but is not operating.
To Next Page
Loading...
